User Guide
Table Of Contents
- Important safety information
- Overview
- Using the cooktop burners
- Care and cleaning of the cooktop
- Troubleshooting
- Warranty
- Appendix
- Información importante de seguridad
- Descripción general
- Uso de los quemadores de la cubierta
- Cuidado y limpieza de la cubierta
- Superficie de la cubierta
- Superficies de porcelana esmaltada (en algunos modelos)
- Superficies de acero inoxidable (en algunos modelos)
- Perillas de control
- Rejillas y componentes de los quemadores
- Tapas y cabezales de los quemadores
- Bases de los quemadores
- Electrodos
- Rejillas y la rejilla para wok
- Comal de hierro fundido (para NA30K7750T*/NA36K7750T* solamente)
- Reemplazo del cabezal y la tapa de los quemadores
- Tapa de los quemadores
- Resolución de problemas
- Garantía
- Apéndice
- Informations importantes relatives à la sécurité
- Présentation
- Utilisation des brûleurs de la table de cuisson
- Entretien et nettoyage de la table de cuisson
- Surface de la table de cuisson
- Surfaces en émail vitrifié (sur certains modèles)
- Surfaces en acier inoxydable (sur certains modèles)
- Boutons de commande
- Grilles et composants des brûleurs
- Chapeaux et têtes des brûleurs
- Bases des brûleurs
- Électrodes
- Grilles et grille du wok
- Gril en fonte (uniquement pour NA30K7750T*/NA36K7750T*)
- Remplacement des chapeaux et têtes des brûleurs
- Chapeau du brûleur
- Dépannage
- Garantie
- Annexe
English 13
Using the cooktop burners
Flame level
The ames on the burners should always stay under the cookware, and should not
extend beyond the cookware bottom at any time.
WARNING
• Flames larger than the cookware bottom may result in a re or physical injury.
• When you set a burner to simmer, do not turn the burner knob quickly. Watch the
ame to make sure it stays on.
• After turning on a surface burner, make sure that the burner has ignited even if
the knob LED is on. Adjust the level of the ame by turning the burner knob.
• Always turn off the surface burner controls before removing cookware. All
surface burner controls should be turned OFF when you are not cooking.
• Always turn the burners off before you go to sleep or go out.
• If you smell gas, turn off the gas to the cooktop and call a qualied service
technician. NEVER use an open ame to locate a leak.
• If the LED on the control knob doesn't go on when the surface burner has ignited,
call a qualied service technician.
• If the knob LED illuminates, but the surface burner does not ignite, turn off the
control knob immediately.
• Do not operate the burner for an extended period of time without cookware on
the grate. The nish on the grate may chip without cookware to absorb the heat.
• Be sure the burners and grates are cool before you place your hand, a pot holder,
cleaning cloths or other materials on them.
Cookware
Requirements
• Flat bottom and straight sides
• Tight-tting lid
• Well-balanced with the handle weighing less than the main portion of the pot or
pan.
Material characteristics
• Aluminum: An excellent heat conductor. Some types of food may cause the
aluminum to darken. However, anodized aluminum cookware resists staining and
pitting.
• Copper: An excellent heat conductor but discolors easily.
• Stainless steel: A slow heat conductor with uneven cooking performance but is
durable, easy to clean, and resists staining.
• Cast-Iron: A poor conductor but retains heat very well.
• Enamelware: Heating characteristics depend on the base material.
• Glass: A slow heat conductor. Use only glass cookware that is specied for
cooktop cooking or oven use.
• Heatproof Glass-Ceramic: Can be used for either surface or oven cooking. It
conducts heat very slowly and cools very slowly. Check cookware manufacturer's
directions to be sure it can be used on a gas cooktop.
Size limitations
10 inches
or more
10 inches
or more
CAUTION
• Do not place a pan or pot with a bottom
diameter of about 10 inches or more on
the RF or LF burner.
NA30N6555TG_DG68-01089A-01_EN+MES+CFR.indb 13 5/28/2018 12:47:19 PM