User Manual
English 25
Installation instructions
NOTE
Save these orices and note their positions for future conversions back to natural
gas.
3. Locate the LP conversion orices that were shipped with the cooktop.
4. Identify the proper orice by orice size for each of the cooktop burners.
5. Install the proper orices in each of the burner manifold cups and tighten with
a
9
/32” or 7 mm nut driver.
NOTE
Any other placement of orices could result in dangerous operating conditions
and/or poor cooking results.
6. Set all burner heads on top of the manifold cups in the same location as
they were removed. The hole on the side of the burner heads goes over the
electrodes. The burner heads are correctly installed when they are at on the
top of the manifold cups.
7. Set all burner caps on top of the burner heads. These are also at when they are
installed to ensure proper safe operation.
Converting the cooktop burners
NOTE
If you are using LP gas to fuel the cooktop, the following steps and conversions
must be made before the ames can be adjusted.
1. Lift off the cooktop burner caps and the cooktop burner heads from the cooktop
burner manifold cups.
Cap
Burner Head
Burner Cup
Cooktop Burner Locations
2. Using a
9
/32” or 7 mm nut driver, remove the burner orice from the bottom of
each burner manifold cup.
Cooktop
Burner Orice
Install_NA9300K_DG68-00841A-03_EN+MES+CFR.indb 25 2017-08-16 2:49:38