Installation Instructions

26 English

Installation instructions

Combustion ame quality

1. Soft blue ames—Normal for natural gas

operation.

2. Yellow tips on outer cones—Normal for

LP gas operation.

3. Yellow ames—Abnormal for any gas

operation. Further adjustment required.

Additional low ame check

1. Quickly open and close the cabinet door while the cooktop burner is set on LO.

If the ame is extinguished, increase the low ame setting and repeat the test

until the ame is stable.

2. Turn the knob from HI to the lowest setting quickly. If the ame goes out at the

lowest setting, increase the low ame setting and repeat the test until the ame

is stable.

Adjusting low ame setting on cooktop burners

All Cooktop burner ames should be checked at their lowest setting. Use the

following steps to check and adjust the cooktop burner settings.

NOTES

• Low setting adjustments should always be made with two or more burners

operating at the same time.

• Call for service when you need to adjust the inner ame of the cooktop center

burner settings.

1. Turn on two or more cooktop burners and set them between MED and HI.

2. Quickly turn one of the control knobs counterclockwise to the lowest setting.

The ame should stay lit. If the ame utters or goes out, adjust the bypass

valve on the control valve for that burner.

3. Pull the control knob for that burner straight off.

4. Using a small at-bladed screwdriver, adjust the bypass valve screw in the base

of the valve stem. Turn the bypass valve screw counter clockwise to increase

the ame size.

Flat-bladed

screwdriver

Value Stem

Inner ame

bypass screw

Dual valve

Outer ame

bypass screw

5. Replace control knob and recheck the low ame setting.

6. Repeat step 1 thru 5 to check and adjust the low ame settings on the

remaining cooktop burners.

Install_NA30N6555TG_DG68-01091A-01_EN+MES+CFR.indb 26 5/28/2018 12:50:44 PM