User Manual
Table Of Contents
- NA5300R_DG68-01132A-00_EN
- NA5300R_DG68-01132A-00_MES
- Información importante de seguridad
- Descripción general
- Uso de los quemadores de la cubierta
- Cuidado y limpieza de la cubierta
- Superficie de la cubierta
- Superficies de porcelana esmaltada (en algunos modelos)
- Superficies de acero inoxidable (en algunos modelos)
- Perillas de control
- Rejillas y componentes de los quemadores
- Tapas y cabezales de los quemadores
- Bases de los quemadores
- Electrodos
- Rejillas
- Reemplazo del cabezal y la tapa de los quemadores
- Tapa de los quemadores
- Resolución de problemas
- Garantía limitada (Estados Unidos)
- Garantía (CANADÁ)
- NA5300R_DG68-01132A-00_CFR
- Informations importantes relatives à la sécurité
- Présentation
- Utilisation des brûleurs de la table de cuisson
- Entretien et nettoyage de la table de cuisson
- Surface de la table de cuisson
- Surfaces en émail vitrifié (sur certains modèles)
- Surfaces en acier inoxydable (sur certains modèles)
- Boutons de commande
- Grilles et composants des brûleurs
- Chapeaux et têtes des brûleurs
- Bases des brûleurs
- Électrodes
- Grilles
- Remplacement des chapeaux et têtes des brûleurs
- Chapeau du brûleur
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
18 English
Care and cleaning of the cooktop
Care and cleaning of the cooktop
Burner caps and heads
NOTES
Before removing the burner caps and heads, remember their size and location.
Replace them in the same location after cleaning.
Wash burner caps and burner heads in hot, soapy water and rinse with clean
running water. You may scour with a plastic scouring pad to remove burned-on
food particles.
Use a sewing needle or twist tie to unclog the small holes in the burner head, if
required.
CAUTION
• Do not wash any burner parts in a dishwasher.
• Do not use steel wool or scouring powders to clean the burners.
Burner bases
CAUTION
The burner bases cannot be removed for cleaning.
Round burner base
Electrode
Make sure that no water gets into the
burner bases and the brass gas orices.
Wipe clean with a damp cloth. Be careful
not to scratch, deform, or damage the
bases. Allow them to dry fully before using.
Electrodes
CAUTION
Do not attempt to remove the electrode from the cooktop or burner bases.
01
02
01 Clean this metal part
02 Do not clean this white ceramic
part with an emery board
Be careful not to push in any cooktop
controls while cleaning the cooktop. A slight
electrical shock might result which could
cause you to knock over hot cookware.
Make sure that the white ceramic electrodes
in the cooktop are clear of soil and dry.
Clean the metal part of the electrode with
a soft cloth. Do not use water to clean the
igniters.
Before reassembling the surface burners,
push down gently on each of the white
ceramic, electrodes to make sure they are
pressed against the burners bases.
NOTE
Do not attempt to remove the electrode
from the cooktop.
NA5300R_DG68-01132A-00_EN.indd 18 2019-04-19 4:46:13