Installation Guide

24 English

Installation instructions

Required tools

Adjustable wrench

/2” open-end wrench Screwdrivers: Phillips

Small at-bladed

precision screwdriver

Nut drivers:

/32” or

7 mm

To convert your for use with LP gas, perform the following steps and procedures:

1. Disconnect electrical power to the cooktop. Unplug the cooktop power cord, trip

the circuit breaker, or remove the fuse from the fuse box.

2. Shut off the gas supply to the cooktop. Close the manual shut-off valve to the

cooktop.

Converting the pressure regulator

NOTE

If you are using LP gas to fuel the cooktop, the following steps and conversions

must be made before the ames can be adjusted.

1. Using your ngers, turn the cap. And carefully look at the spring retainer to

locate the NAT or LP position.

NAT

NAT. Position

L.P./Propane

Position

Pressure Regulator

Spring

Retainer

NATCap

Gasket

2. Turn the spring retainer over by rotating it 90 deg., pull it from the cap, turn the

spring retainer over so that LP is showing, insert it back into the cap, and then

rotate it 90 deg. Into position.

3. Screw the cap back onto the regulator and tighten.

Install_NA30R5310FG_AA_DG68-01133A-00_EN.indd 24 2019-04-12  12:13:38