User Manual

English 53
Maintaining your appliance
5. Repeat for the right (front and
back) slide mechanism of the rack.
6. Open and close the rack several
times to distribute the lubricant.
7. Replace the cap on the lubricant
and shake it again. Turn the rack over
and repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-
side-up and place in the oven. See
installing the gliding rack in the USING
THE GLIDING RACK section.
NOTE
• Do not spray the gliding rack with
cooking spray or other lubricant sprays.
Oven door
Don’t hand
clean the
oven door
gasket.
You may
hand clean
the door.
• Use soap & water to thoroughly clean
the top, sides, and front of the oven
door. Rinse well. You may use a glass
cleaner on the outside glass of the
oven door. DO NOT immerse the door
in water. DO NOT spray or allow water
or the glass cleaner to enter the door
vents. DO NOT use oven cleaners,
cleaning powders, or any harsh
abrasive cleaning materials on the
outside of the oven door.
• DO NOT clean the oven door gasket.
The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.
To lubricate the slides
1. Remove the rack from the oven. See
removing the gliding rack in the USING
THE GLIDING RACK section.
2. Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3. If there is debris in the slide
tracks, wipe it away using a paper
towel. (Any graphite lubricant wiped
away must be replaced - See steps 4
through 7.
4. Shake the graphite lubricant
before opening it. Starting with the
left (front and back) slide mechanism
of the rack, place four (4) small drops
of lubricant on the two (2) bottom
tracks of the slide close to the bearing
carriers.