Use and Care Guide

English 51
Troubleshooting
DRAWER
Problem Possible cause Solution
The Drawer
does not slide
smoothly or
drags.
The drawer is out of
alignment.
Fully extend the drawer and push it
all the way in. See the page 45.
The drawer is over-
loaded or the load is
unbalanced.
Reduce weight. Redistribute drawer
contents.
The Warming
drawer will not
work.
A fuse in your home
may be blown or circuit
breaker tripped.
Replace the fuse or reset the circuit
breaker.
The controls are not set
correctly.
See the chapter on using the
warming drawer on pages 37-38.
Excessive
condensation
in the drawer.
There is liquid present in
the drawer.
Remove the liquid.
Uncovered foods. Cover food with a lid.
The temperature is set
too high.
Adjust the temperature to a lower
setting.
Food dries out
in the warming
drawer.
Moisture is escaping. Cover food with a lid.
The drawer is not fully
closed.
Push the drawer in until the latch
engages.
Information codes
OVEN
Displayed Code Possible cause Solution
C-20 The oven sensor is
open when the oven is
operating.
Press OVEN OFF and restart the
oven. If the problem persists,
disconnect all power to the range
for at least 30 seconds and then
reconnect the power. If this does
not solve the problem, call for
service.
The oven sensor is
short when the oven is
operating.
C-21 This code occurs if the
internal temperature
rises abnormally high.
C-d1 This code occurs
if the door lock is
mispositioned.
C-d0 This code occurs if the
Control key is short for
1 minute.
Press OVEN OFF and restart the
oven. If the problem persists,
disconnect all power to the range
for at least 30 seconds and then
reconnect the power. If this does
not solve the problem, call for
service.
C-30 The PCB sensor is
open when the oven is
operating.
The PCB sensor is
short when the oven is
operating.
C-31 This code occurs if the
PCB temperature rises
abnormally high.
Call for service.