Use and Care Guide
Table Of Contents
- Important safety instructions
- Introducing your new range
- Before you begin
- Surface cooking
- Operating the oven
- The oven control panel
- Oven lock
- Setting the clock
- Setting the kitchen timer
- Timed cooking
- Delay start
- Turning the oven light on and off
- Minimum and maximum settings
- Using the oven racks
- Baking
- Broiling
- Using the bread proof function
- Using the keep warm feature
- Using the smart control feature
- Using the voice control
- Using the options function
- Using the Sabbath feature
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Appendix
- Instrucciones de seguridad importantes
- Introducción a su nueva estufa
- Antes de comenzar
- Superficie de cocción
- Superficie de cocción
- Funcionamiento del horno
- Panel de control del horno
- Bloqueo del horno
- Ajuste del reloj
- Cómo programar el temporizador de cocina
- Cocción por temporizador
- Retrasar el inicio
- Cómo encender y apagar la luz del horno
- Ajustes mínimos y máximos
- Uso de las parrillas del horno
- Hornear
- Asar a la parrilla
- Cómo usar la función de levantamiento del pan
- Cómo usar la función de mantener caliente
- Uso de la función de control inteligente
- Uso de la función de control por voz
- Cómo usar la función de opciones
- Uso de la función Sabbat
- Mantenimiento de su electrodoméstico
- Resolución de problemas
- Garantía (EE.UU.)
- Garantía (CANADÁ)
- Apéndice
- Consignes de sécurité importantes
- Présentation de votre nouvelle cuisinière
- Avant de commencer
- Table de cuisson
- Utilisation du four
- Utilisation du four
- Réglage de l'horloge
- Réglage de la minuterie
- Cuisson minutée
- Départ différé
- Activation et désactivation de l'éclairage du four
- Réglages minimum et maximum
- Utilisation des grilles du four
- Cuisson traditionnelle
- Cuisson au gril
- Utilisation de la fonction Pain précuit
- Utilisation de la fonction Maintien au chaud
- Utilisation de la fonction Smart Control
- Utilisation de la fonction commande vocale
- Utilisation de la fonction des options
- Utilisation de la fonction Sabbat
- Entretien de votre appareil
- Dépannage
- Garantie (ÉTATS-UNIS)
- Garantie (CANADA)
- Annexe
English 47
Troubleshooting
Problem Possible cause Solution
The surface unit
frequently cycles
on and off.
The element will cycle on
and off to maintain the
power setting.
This is normal operation,
and not a system failure.
Use the range as usual.
The surface unit
stops glowing when
changed to a lower
setting.
This is normal. The unit is still on and hot.
Scratches or
abrasions on the
cooktop surface.
The cooktop is being
cleaned improperly.
Scratches are not
removable. Tiny scratches
will become less visible in
time as a result of cleaning.
Use ceramic glass top
cleaning cream. Do not
use chemical or corrosive
agents. These agents may
damage the surface of the
product.
Cookware with rough
bottoms was used on the
cooktop or there were
coarse particles (e.g., salt or
sand) present between the
cookware and the surface
of the cooktop.
To avoid scratches, follow
the recommended cleaning
procedures. Make sure
cookware bottoms are
clean before use, and use
cookware with smooth
bottoms.
Cookware has been slid
across the cooktop surface.
Problem Possible cause Solution
Brown streaks or
specks.
Boilovers have been cooked
onto the surface.
• Wait until the surface
cools down. Then,
use a single-edge
razor-blade scraper at
approximately a 45°
angle against the glass
surface to remove the
soil.
• See the section on the
care and cleaning of
the glass cooktop on
page 41.
Areas of
discoloration with
metallic sheen.
Mineral deposits from
water and food have been
left on the surface of the
cooktop.
• Remove using a
ceramic-glass cooktop
cleaning cream.
• Use cookware with
clean, dry bottoms.
Clean the cooktop with
a ceramic cleaning
agent regularly every
week.
"Cracking" or
"popping" sound.
This is the sound of the
metal heating and cooling
during the cooking
functions.
This is normal operation,
and not a system failure.
Use the range as usual.