Installation Guide
English 5
Preparing to install the range
CAUTION
You must use the rear ller kit to install the range in a freestanding cutout cabinet.
For more information, see “Optional rear ller kit” as shown below.
NOTE
If you install the product in a kitchen island, you must maintain minimum 2-1/2"
from cutout to back edge of the countertop and minimum 3" from cutout to side
edges of the countertop.
Optional rear ller kit
Used to ll gap between the range back and wall. Adds a ller strip to the rear
of the range. This kit can only be used when the opening in the countertop is 25"
deep.
1. Unscrew the screws afxing the vent cover.
2. Assemble the ller strip to the back of the range using the removed screws.
NOTE
If the countertop depth is greater than 25", there will be a gap between the ller
kit and the back wall.
Install_NE63T8911_AA_DG68-01257A-00_EN.indd 5 3/19/2020 4:15:00 PM