User Manual
Table Of Contents
- Important safety instructions
- What you need to know about safety instructions
- California Proposition 65 Warning
- For your safety
- Induction cooktop elements
- Electrical safety
- Child safety
- Oven
- Remote Operation
- Self-cleaning ovens
- Ventilating hood
- Glass/Ceramic cooking surfaces
- Critical installation warnings
- Critical usage warning
- Usage cautions
- Critical cleaning warnings
- Introducing your new range
- Before you begin
- Surface cooking
- About induction cooktop cooking
- How to set the appliance for cooktop cooking
- Before using the cooktop
- Cookware for induction cooking zones
- Using the correct size cookware
- Pot and pan sizes
- Induction cookware test
- Operating noises
- Using suitable induction cookware
- Temperature detection
- Suggested settings for cooking specific foods
- Protecting the cooktop
- Operating the oven
- The oven control panel
- How to use dial knob
- Lock
- Display mode
- Turning the oven light on and off
- Clock
- Dual Door™
- Single mode
- Twin mode
- Cooking mode
- Twin Mode Temperature setting ranges
- Using the oven racks
- Using the gliding rack
- Using the divider
- Recipe guide
- Temperature probe (Single Mode Only)
- Cooking options
- Special features
- More functions
- System Settings
- Smart control
- Voice control
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Appendix
English 65
Maintaining your appliance
Removing and reinstalling the storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Using both hands, pull down the
left clip while lifting the right clip, and
then remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4. Put the drawer in the roller guides on
either side, and then snap the clips into
place.
How to reinstall the door
You can replace the upper door the same way you replace the full door.
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Bottom Bottom
edge of edge of
slotslot
IndentationIndentation
Hinge Hinge
armarm
3. Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
Hinge lockHinge lock
Locked positionLocked positionUnlocked positionUnlocked position
5. Close the oven door.