User Manual (Vista)

129
Turning the Computer On
Thisfunctionisappliedtosomemodelsonly.
TousetheTurnthecomputeronfunction,youhaveto
registeryourngerprintrstandcongureitasfollows.
Whennishingthesettings,youcanturnthecomputeron
throughngerprintidenticationorintegratedpassword
authenticationinsteadofenteringapassword.
1
 SelectStart > All Programs(orProgram)> Softex
> OmniPass Control Center.
2
 SelectChange System Settingsandthenselect
either Enable or disable pre-boot authentication
or Do Not Use Authentication before Boot.
3
 SelectEnable System Boot Authentication and
clickthe Nextbutton.
4
Enter the Boot Password Settingandclickthe
Next button.
5
 ClickFinishtocompletetheTurnthecomputeron
functionsettings.
Whenturningthecomputeron,thefollowingscreen
appears.Placeyourngeroverthengerprint
identication sensor and
thenremoveit.
To use a booting password instead of ngerprint
identication,
pressthe<ESC>keytodisplaythe
bootingpasswordinputscreen.Enterthebooting
passwordinthescreen.Thenyoucanbootupyour
computer.
Youcanattemptthengerprintidenticationuptothree
times.Ifallthethreeattemptsfail,thecomputerwill
automaticallyshutdown.Inthiscase,turnthecomputer
onagainandretrythengerprintidenticationorenter
thebootingpassword.
Canceling the Settings
UnselecttheSystem Boot Authentication Available
option
inStep3above,andthencongureitaccording
totheinstructionsthatappearonthescreen.