User Manual
31
Unintentional Emitter per FCC Part 15
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:(1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy. If not installed and used in accordance with
the instructions, it may cause harmful interference.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
If necessary, the user should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may nd the following booklet
helpful: “Something About Interference.”
This is available at FCC local regional ofces. Our
company is not responsible for any radio or television
interference caused by unauthorized modications of this
equipment or the substitution or attachment of connecting
cables and equipment other than those specied by our
company. The correction will be the responsibility of the
user. Use only shielded data cables with this system.