User Manual

32
Intentional emitter per FCC Part 15
(If tted with 2.4G band or 5G band)
Low power, Radio LAN type devices (radio frequency
(RF) wireless communication devices), operating in the
2.4GHz/5GHz Band, may be present (embedded) in your
notebook system. This section is only applicable if these
devices are present. Refer to the system label to verify
the presence of wireless devices.
Wireless devices that may be in your system are only
qualied for use in the United States of America if an FCC
ID number is on the system label.
This device is restricted to indoor use due to its operation
in the 5.15 to 5.25 GHz frequency range. FCC requires
this product to be used indoors for the frequency range
5.15 to 5.25 GHz to reduce the potential for harmful
interference to co-channel Mobile Satellite systems. High
power radars are allocated as primary users of the 5.25
to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar
stations can cause interference with and /or damage this
device.
The FCC has set a general guideline of 20 cm (8 inches)
separation between the device and the body, for use of
a wireless device near the body (this does not include
extremities). This device should be used more than 20
cm (8 inches) from the body when wireless devices are
on. The power output of the wireless device (or devices),
which may be embedded in your notebook, is well below
the RF exposure limits as set by the FCC.
This transmitter must not be collocated or operate in
conjunction with any other antenna or transmitter except
the installed Bluetooth transmitter.
Operation of this device is subject to the following
two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation of the device.
Wireless devices are not user serviceable. Do not
modify them in any way.
Modication to a wireless device will void the
authorization to use it. Contact manufacturer for
service.
FCC Statement for Wireless LAN use:
“While installing and operating this transmitter and
antenna combination the radio frequency exposure limit
of 1mW/cm2 may be exceeded at distances close to the
antenna installed. Therefore, the user must maintain
a minimum distance of 20cm from the antenna at all
times.
This device can not be colocated with another
transmitter and transmitting antenna.”