User manual

13
Available Combinations and Restrictions
Restrictions by
Module
○ : Available, △ : Version 2.0 or higher required, : Not available
(1)
Restrictions on available link modules
Module
Configuration
Basic module Specialty module Network module
Processor module Backplane (3, 5, 8, 10, and 12-slot) Power supply module Input module Output module A/D, D/A, RTD, TC modules Positioning module (1,2,3 and 4 axes) High-speed counter (1, 2CH) High-performance high-speed counter (4CH) Pulse I/O module (4CH) SCU (2CH) CCU+ 1CH) Remote I/O master module Remote I/O slave module MW-Link module EtherNet module DeviceNet master module Profi-DP master module
(1) (1) (1) (1) (1)
Base backplane
Mount the modules in the following
order, starting from the leftmost slot of
the backplane.
• Power supply module
• Processor module
• I/O module or specialty module
○○○○○○
△
○
△△
○○
△△△

△△
Expansion backplane
Mount the modules in the following
order, starting from the leftmost slot of
the backplane.
• Power supply module
• I/O module or specialty module

○○○○○

○

○

Module Availability with NX-CPU700p
CCU+ Only one unit available
MW-Link module
W-Link mode Available with NX-CPU700p version 2.0 or higher
W-Link 2 mode Unavailable
EtherNet module Unavailable
Remote I/O Master and Slave modules Available with NX-CPU700p version 2.0 or higher
Positioning, High-performance high-speed counter
(4CH), and Pulse I/O modules
Available with NX-CPU700p version 2.0 or higher