er Manual
Table Of Contents
- NV51R5511D_AA_DG68-01126A-02_EN
- Important safety instructions
- Introducing your new oven
- Before you begin
- Operating the oven
- The oven control panel
- Control panel display modes
- Setting the clock
- Setting the kitchen timer
- Control Lockout
- Timed Cooking
- Delay Start
- Turning the light on and off
- Minimum and maximum settings
- Using the oven racks
- Baking
- Broiling
- Using Bread Proof
- Using Keep Warm
- Using Settings
- Using the Sabbath feature
- Using Smart Control
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- NV51R5511D_AA_DG68-01126A-02_MES
- Instrucciones de seguridad importantes
- Introducción a su nuevo horno
- Antes de comenzar
- Funcionamiento del horno
- Panel de control del horno
- Modos de pantalla del panel de control
- Ajuste del reloj
- Cómo programar el temporizador de cocina
- Traba de controles
- Cocción con temporizador
- Inicio retardado
- Cómo encender y apagar la luz
- Ajustes mínimos y máximos
- Uso de las parrillas del horno
- Horneado
- Asado a la parrilla
- Uso de Levantamiento del pan
- Uso de Mantener Temperatura
- Uso de Configuración
- Uso de la función Shabat
- Uso de Smart Control
- Mantenimiento de su electrodoméstico
- Resolución de problemas
- Garantía limitada (Estados Unidos)
- Garantía (CANADÁ)
- NV51R5511D_AA_DG68-01126A-02_CFR
- Consignes de sécurité importantes
- Présentation de votre nouveau four
- Avant de commencer
- Utilisation du four
- Panneau de commande du four
- Modes d'affichage du panneau de commande
- Réglage de l'horloge
- Réglage de la minuterie
- Verrouillage des commandes
- Cuisson minutée
- Départ différé
- Activation et désactivation de l'éclairage
- Réglages minimum et maximum
- Utilisation des grilles du four
- Cuisson traditionnelle
- Cuisson au gril
- Utilisation de la fonction Pain précuit.
- Utilisation de la fonction Maintien au chaud
- Utilisation de la fonction Paramètres
- Utilisation de la fonction Shabbat
- Utilisation de la fonction Commande intelligente
- Entretien de votre appareil
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
English 33
Maintaining your appliance
Replacing the oven doors
CAUTION
The door is very heavy. You may need help lifting the door high enough to slide it
into the hinge slots. Do not lift the door by the handle.
A
A. Slot in the oven cavity for the
door hinge lock
1. Using two hands, grasp the side edges
of the door at the midpoint.
Face the oven cavity.
2. Locate the slots on each side of the
oven cavity for the door hinge locks.
3. Hold the door at a 45° angle, and then
align the door hinges with the slots
in the lower front of the oven cavity.
Slowly insert the door, making sure you
maintain the 45° angle. You will know
the door is engaged in the slot when
you feel a slight drop.
4. Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5. Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the
“Removing the oven doors” section for
the proper locked position.
6. Close the oven door.
7. When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven door
is hanging lower than the other, the hinge
on that side is not properly installed.
NV51R5511D_AA_DG68-01126A-02_EN.indd 33 11/5/2019 10:31:09 AM