Use and Care Guide

English - 55
07 MAINTENANCE
Burner grates and components
Turn off all surface burners, and make sure they are all cooled down.
1
3
2
1. Remove the burner grates.
2. Remove the burner caps from the burner
heads.
3. Remove the burner heads from the valve
manifolds to reveal the starter electrodes.
4. Clean all removable grates and burner
components in warm, soapy water. Do not
use steel-wool pads or abrasive cleaners.
5. Rinse and dry grates with burner
components thoroughly.
8
6
7
6. Return the burner heads to their positions on
top of the manifold valves. Make sure a starter
electrode is inserted through the hole in each
burner head.
7. Return the burner caps to their positions on
top of burner heads. To ensure proper and
safe operation, make sure the burner caps lie
flat on top of the burner heads.
8. Reinstall the burner gates in their respective
positions.
9. Turn on each burner and check if it operates
properly. After verifying that a burner
operates normally, turn it off.
The precise simmer burner (RR) cap and the inner dual burner (RF) cap are interchangeable.
Top Bottom
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by force.
• Make sure all burner components (heads and caps) are reinstalled properly. They are stable
and rest flat when installed properly.
• To avoid chipping, do not bang grates and caps against each other or hard surfaces such
as cast iron cookware.
• The burner spreader can be blocked by food or dust. Clean the spreader if it appears
blocked. If you clean the spreader with water, assemble it only after it is completely dry. If
the spreader is wet, it might prevent the burners from igniting.
NX58H9500WS_DG68-00566A-08_EN+MES+CFR.indb 55 2016-09-08  2:14:08