User Manual
Table Of Contents
- Important safety information
- Overview
- Gas range
- Gas oven
- Maintenance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Información importante de seguridad
- Lea todas las instrucciones antes de usar este artefacto
- Símbolos usados en este manual
- California Proposición 65 Advertencia
- Mancomunidad de Massachusetts
- Seguridad general
- Seguridad contra incendios
- Seguridad del gas
- Seguridad de la electricidad y la conexión a tierra
- Seguridad de la instalación
- Seguridad de la ubicación
- Seguridad de la cubierta
- Seguridad del horno
- Información de seguridad del cajón de almacenamiento
- Descripción general
- Estufa de gas
- Horno de gas
- Mantenimiento
- Resolución de problemas
- Garantía limitada (Estados Unidos)
- Garantía (CANADÁ)
- Informations importantes relatives à la sécurité
- Lisez toutes les consignes de sécurité avant d'utiliser l’appareil.
- Symboles utilisés dans ce manuel
- California Proposition 65 Avertissement
- Commonwealth du Massachusetts
- Sécurité générale
- Sécurité incendie
- Sécurité liée au gaz
- Sécurité électrique et mise à la terre
- Sécurité liée à l'installation
- Sécurité de l'emplacement
- Sécurité liée à la table de cuisson
- Sécurité liée au four
- Sécurité du tiroir de rangement
- Présentation
- Cuisinière à gaz
- Four à gaz
- Entretien
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
22 English
Maintenance
Maintenance
NOTE
• After cleaning, conrm that the burner port openings aren't plugged.
• Shake out any excess water and then let burner heads and caps dry thoroughly.
Placing the center burner upside down will allow the water to drain out more
easily.
• Do not wash any burner components in a dish washer.
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• Make sure all burner components (heads and caps) are reinstalled properly. They
are stable and rest at when installed properly.
• To avoid chipping, do not bang grates and caps against each other or against
hard surfaces such as cast iron cookware.
• Do not attempt to remove center oval burner cap from the head.
CAUTION
• Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage the
enamel surface.
• Do not remove the cooktop surface to clean it. The gas lines leading to the burner
manifolds can be damaged, resulting in a re or system failure.
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
1
3
2
1. Remove the burner grates.
2. Remove the burner caps from the
burner heads.
3. Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4. Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
5. Rinse and dry the grates and burner
components thoroughly.
8
6
7
Top Bottom
6. Return the burner heads to their
positions on top of the manifold valves.
Make sure a starter electrode is inserted
through the hole in each burner head.
7. Return the burner caps to their positions
on top of burner heads. To ensure
proper and safe operation, make sure
the burner caps lie at on top of the
burner heads.
8. Reinstall the burner grates in their
respective positions.
9. Turn on each burner and check if it
operates properly. After verifying that a
burner operates normally, turn it off.