User Manual
English 41
Maintenance
Oven remote control using the SmartThings app
Error Check • Automatically recognize errors.
Temp Probe
• Monitor the current temperature and reset the
probe setting.
• If is not shown in the display, you are still able to monitor the oven and
cooktop status and turn the oven off.
WI-FI On/Off
If you set the WI-FI mode to Off, mobile devices cannot connect to the range.
1
1
2 2
3
1. Press the Options pad, and then 8 on the
number pad.
2. Press 1 (On) or 2 (Off) on the number
pad.
3. Press the START/SET pad to save the
changes.
NOTES
• Opening the oven door or pressing Smart Control will delete from the display
and prevent most of the remote functions from operating.
• When oven cooking is nished or cancelled, is removed from the display.
• For safety reasons, you cannot turn on the gas oven remotely.
• For safety reasons, you must specify the cooking time to enable remote control.
• The oven continues operating even if the Wi-Fi connection is lost.
• Smart Control will not work properly if the Wi-Fi Connection is unstable.
• See the SmartThings app manual for detailed information.
Maintenance
Cleaning
Control panel
First, lock the control panel and the door to prevent accidental operations and/or
product tipping.
1. Press and hold the START/SET pad for 3 seconds to lock both the control panel
and the door.
2. Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3. When done, press and hold the START/SET pad again for 3 seconds.
WARNING
• Make sure the control panel turns off and all surfaces of the range are cool
before cleaning. Otherwise, you can get burned.
• If the range has been moved away from the wall, make sure the anti-tip device is
reinstalled properly when the range has been put into place again. Otherwise, the
range may tip over, causing physical injuries.
• Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1. Remove any spills, spots, and grease stains using a soft, wet cloth.
2. Apply an approved stainless steel cleanser to a cloth or paper towel.
3. Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4. When done, dry the surface using a soft, dry cloth.
5. Repeat steps 2 through 4 as many times as necessary.
CAUTION
• Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
• Do not spray any type of cleanser into the manifold holes. The ignition system is
located in those holes and must be kept free of moisture.