User Manual

22 English
Installation instructions
Installation instructions
Step 7. Assemble the surface burners
CAUTION
Do not operate the surface burners without
all burner parts in place.
1. Position surface burner heads on top of
the surface burner manifolds as shown
at right. The electrodes will t into the
slot in the bottom of the heads. Make
sure the surface burner heads are at
and parallel with the cooktop.
2. Place the matching size caps on top of
each surface burner head.
3. Place the left, center, and right surface
burner grates on the cooktop. The
edges of the grates should match up
with the edges of the cooktop.
Step 6. Level the range
Leveling leg
1. Make sure the range is positioned
where you want it.
2. Using a wrench, level the range by
turning the front leveling legs in or
out as necessary. Counterclockwise
shortens the leg and lowers the range.
Clockwise lengthens the leg and raises
the range.
NOTE
• Adjusting the two front legs is usually
sufcient, but all four legs adjust if
necessary.
• Adjust the leveling legs only as far as
necessary to level the range. Extending
the leveling legs more than necessary
or removing legs can cause the range
to be unstable.
3. If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
4. Position an oven rack in the center rack
position.
5. Check the level of the range with a
carpenter level using the two positions
shown at right.
6. After the range becomes level, slide the
range away from the wall so that the
anti-tip bracket can be installed.
Install_NX58M6850SS_DG68-00910A-02_EN+MES+CFR.indb 22 2017-12-13  5:21:57