User Manual

30 English

Installation instructions

To adjust ame low setting

Identify which burner is exhibiting too high or too low of simmer rate via

manifold panel graphics.

Simmer Set

Screw

1. Rotate a knob to “LO” position and

remove the knob from the valve shaft

while the ame is lit.

2. Carefully push the screw driver into

the C chanel of the valve, until it his

the simmer set screw. Make sure the

screwdriver athead is seated into the

set screw groove.

3. Rotate valve set screw clockwise to decrease “LO” setting ame output, or

rotate set screw counter clockwise to increase “LO” setting ame output.

WARNING

1. Do not completely remove the valve set screw from the valve stem. The valve

set screw is an integral part of the gas valve assembly. Removing the valve set

screw will cause gas to leak.

2. After adjusting the valve set screw, inspect the assembly for gas leaks.

Memo

Install_NX58R4311SS_AA_DG68-01153A-02_EN+MES+CFR.indb 30 2020-06-16 �� 8:30:23