User Manual

50 English
Maintaining your appliance
Maintaining your appliance
7. Set all burner heads on top of the
manifold valves in the same location
you removed them from.
The hole on the side of the burner heads
goes over the electrodes.
The burner heads are correctly installed
when they are at on the top of the
manifold valves.
8. Set all burner caps on top of the burner
heads.
These also need to be at on top of the
burner heads to ensure proper and safe
operation.
9. Replace burner grates on top of the
range cooktop.
2. Lift off and remove the burner grates
from the cooktop. Make note of the
burner sizes and locations of all the
surface burners.
3. Lift off burner caps from top of the
burner heads.
4. Lift the burner heads off the valve
manifolds and starter electrodes.
5. Clean all removable burner parts in
warm, soapy water. Do not use steel-
wool pads or abrasive cleaners on any
burner part.
6. Rinse thoroughly and completely dry all
parts before they are reassembled.
NOTE
• Starter electrodes are not removable
and should only be wiped clean when
the controls are in the OFF position.
• Shake out any excess water and then let
burner heads and caps dry thoroughly.
Placing the center burner upside down
will allow the water to drain out more
easily.
• Do not attempt to remove center oval
burner cap from the head.