Owner's Manual

50 English
Maintenance
Maintenance
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
1. Make sure the oven door is closed completely and unlocked.
2. Tap , and select Self Clean using the dial knob. Then, select the cleaning time
by turning the dial knob one or more times in accordance with the table below.
Left turn Default Right turn
2-hour cycle 3-hour cycle 5-hour cycle
3. Tap START. The oven door is locked and the oven begins to heat up.
4. When the self-cleaning cycle is complete, the oven beeps. The door will remain
locked until the oven temperature falls below 400 °F (200 °C). You can open the
door when it is safe to open.
CAUTION
Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 on the previous page.
2. Select Set Delay Start.
3. Set the time you want the oven to start self-cleaning using the dial knob.
4. Tap START. The oven will start self-cleaning at your specied time.
To cancel the self-cleaning cycle
You may nd it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, tap OFF. The cycle turns off, but the door
remains locked and the Lock icon blinks until the oven temperature falls below 400 °F
(200 °C).
After self-cleaning
The door stays locked until the internal oven temperature falls below 400 °F.
When the oven has cooled down, wipe the oven surfaces with a cloth to remove ash residue.
Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
If you are not satised with the cleaning results, repeat the cycle. Wait until the oven
cools down and then start a new cycle.
The cooling fan automatically runs for certain amount of time after self-cleaning.
Self-cleaning does not operate within 2 hours after running the self-cleaning cycle.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.
NX60T8751SS_AA_DG68-01219A-00_EN.indd 50 3/26/2020 8:39:45 PM