Owner's Manual

52 English

Maintenance

How to reinstall the door

You can reinstall the upper door the same way you reinstall the full door.

1. Firmly grasp both sides of the door at the top.

2. With the door at the same angle as the removal position, slide the indentation

of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge

arm must be fully inserted into the bottom of the slot.

Hinge arm

Indentation

Bottom edge of slot

3. Open the door fully. If the door will not open fully, the indentation is not

inserted correctly in the bottom edge of the slot.

4. Push the hinge locks up against the front frame of the oven cavity into the

locked position.

Unlocked position

Hinge lock

Locked position

5. Close the oven door.

How to remove and reinstall the Storage drawer

Storage drawer

1. Slide open the drawer until it stops.

2. Locate the roller guide clips on either

side. Using both hands, pull down the left

clip while lifting the right clip, and then

remove the drawer.

3. Clean the drawer in warm, soapy water

using a cloth or soft brush. Then, rinse

and dry it thoroughly.

4. Put the drawer in the roller guides on

either side, and then snap the clips into

place.

NX60T8751SS_AA_DG68-01219A-00_EN.indd 52 3/26/2020 8:39:47 PM