Installation Guide 2020.04.14
Table Of Contents
- Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN
- Before you begin
- Important safety information
- Gas range components
- Installation requirements
- Installation instructions
- Installing your gas range
- Step 1. Unpack the range
- Step 2. Connect the range to gas supply
- Step 3. Convert to lp gas (optional)
- Step 4. Install the anti-tip device
- Step 5. Plug in and place
- Step 6. Level the range
- Step 7. Assemble the surface burners
- Step 8. Check the ignition of surface burners
- Step 9. Final installation checklist
- Adjusting the oven burner air adjustment shutters
- Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_MES
- Antes de comenzar
- Información importante de seguridad
- Componentes de la estufa a gas
- Requisitos de instalación
- Instrucciones de instalación
- Instalación de la estufa de gas
- Paso 1. Desembalaje de la estufa
- Paso 2. Conexión de la estufa al suministro de gas
- Paso 3. Conversión a gas LP (opcional)
- Paso 4. Instalación del dispositivo anti inclinación
- Paso 5. Enchufe y ubicación
- Paso 6. Nivelación de la estufa
- Paso 7. Montaje de los quemadores superiores
- Paso 8. Verificación del encendido de los quemadores superiores
- Paso 9. Lista de verificación final de la instalación
- Ajuste de los obturadores de ajuste del aire de los quemadores del horno
- Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_CFR
- Avant de commencer
- Informations importantes relatives à la sécurité
- Composants de la cuisinière à gaz
- Conditions d'installation
- Consignes d'installation
- Installation de votre cuisinière à gaz
- Étape 1 : déballage de la cuisinière
- Étape 2 : raccordement de la cuisinière à l'arrivée de gaz
- Étape 3 : conversion au GPL (facultatif)
- Étape 4 : installation du dispositif anti-basculement
- Étape 5 : branchement et mise en place
- Étape 6 : mise à niveau de la cuisinière
- Étape 7 : montage des brûleurs de la surface de cuisson
- Étape 8 : vérification de l'allumage des brûleurs de surface
- Étape 9 : vérification finale de l'installation
- Réglage des volets d'air du brûleur du four
English 13
Installation requirements
CAUTION
Do not grasp the knob, handle and push when you install.
CAUTION
DO NOT install the oven so that the door is ush with the cabinet.
For OTR over Gas Stove, please follow local GAS CODE.
Installation requirements
Location requirements
Clearances and dimensions
BEFORE YOU BEGIN to install this appliance, refer to the following information,
dimensions, and clearances. Do not locate the range where it may be subject
to strong drafts. Provide adequate clearances between the range and adjacent
combustible surfaces. These dimensions must be met for safe use of the range.
The location of the electrical outlet and gas piping may be adjusted to meet the
following dimensions and clearances.
For installation in Canada, a free-standing range is not to be installed closer than
4.7 in (12 cm) from any adjacent surface.
CAUTION
This range has been designed to comply with the maximum allowable wood
cabinet temperature of 194 °F (90 °C). Make sure the wall covering, countertops,
and cabinets around the range can withstand the heat (up to 194 °F [90 °C])
generated by the range. If not, discoloration, delamination, or melting may occur.
0 in
(0 cm)
24 in
(61 cm)
Lower
Cabinet
Depth
4 in
(10.2 cm)
6 in
(15.2 cm)
Side
Clearance
Above
Cooking
Surface to
Wall
36 in
(91.4 cm)
30 in
(76.2 cm)
18 in
(45.7 cm)
24.2 in
(61.5 cm)
30 in
(76.2 cm)
0 in (0 cm)
Clearance
Below
Cooking Top
and at Rear
and Sides of
Range
Minimum from
top of cooktop to
cabinets
13 in (33 cm)
Overhead
Cabinet Depth
Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN.indd 13 2020-03-26 6:41:22