Installation Guide

English 25
Installation instructions
To adjust ame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold
panel graphics.
Simmer Set
Screw
1. Rotate a knob to LO position and remove
the knob from the valve stem while the
ame is lit.
Small
Screwdriver
Valve Stem
2. Carefully push the screw driver into the
stem of the valve, until it hits the simmer
set screw. Make sure the screwdriver
athead is seated into the set screw
groove.
3. Rotate valve set screw clockwise to
decrease LO setting ame output, or
rotate set screw counter clockwise to
increase LO setting ame output.
WARNING
1. Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve set
screw will cause gas to leak.
2. After adjusting the valve set screw, inspect the assembly for gas leaks.
Memo
Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN.indd 25 2020-03-26  6:41:26