User Manual

ManualsBrandsSamsung ManualsCookingNX60T8511ST Samsung 30" Front Control Wifi Enabled Slide-In Gas Range with Air Fry and Convection - Fingerprint Resistant Tuscan Stainless Steel

English 39

Maintenance

Burner grates and components

Turn off all surface burners and make sure they have all cooled down.

1. Remove the center burner grate(C)

following both sides grates.(L/R)

2. Remove the burner caps from the burner

heads.

3. Remove the burner heads from the

valve manifolds to reveal the starter

electrodes.

4. Clean all removable grates and burner

components in warm, soapy water. Do

not use steel-wool pads or abrasive

cleaners.

5. Rinse and dry grates and burner

components thoroughly.

6. Return the burner heads to their

positions on top of the manifold valves.

Make sure a starter electrode is inserted

through the hole in each burner head.

NOTE

See the next page for detailed burner

component re-assembly instructions.

7. Return the burner caps to their positions

on top of the burner heads. To ensure

proper and safe operation, make sure the

burner caps lie at on top of the burner

heads.

8. Reinstall the burner grates in their

respective positions.

9. Turn on each burner and check if it

operates properly. After verifying that a

burner operates normally, turn it off.

Brass burner head

NOTE

• The brass parts of your burner will change

color with use. However, this will not

affect performance and you can clean the

brass parts with a brass cleaner.

• After cleaning, conrm that the burner

port openings aren't plugged.

• Shake out any excess water and then let

burner heads and caps dry thoroughly.

Placing the center burner upside down

will allow the water to drain out more

easily.

• Do not wash any burner components in a

dish washer.

CAUTION

• The starter electrodes are not removable. Do not attempt to remove them by

force.

• To avoid chipping, do not bang grates and caps against each other or against

hard surfaces, such as cast iron cookware.

• The burner head can be blocked by food or dust. Clean the head if it appears

blocked. If you clean the head with water, assemble it only after it is completely

dry. If the head is wet, it might prevent the burners from igniting.

• To avoid falling down the grates, make sure to remove both sides grates rst.

• Do not attempt to remove center oval burner cap from the head.

NX9000T_NX60T8511SS_AA_DG68-01221A-06_EN+MES+CFR.indb 39NX9000T_NX60T8511SS_AA_DG68-01221A-06_EN+MES+CFR.indb 39 2021-03-16 �� 10:18:462021-03-16 �� 10:18:46