User Manual
English  45
Maintenance
How to remove and reinstall the Storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either 
side. Using both hands, pull down the left 
clip while lifting the right clip, and then 
remove the drawer.
3. Clean the drawer in warm, soapy water 
using a cloth or soft brush. Then, rinse 
and dry it thoroughly.
4. Put the drawer in the roller guides on 
either side, and then snap the clips into 
place.
How to reinstall the door
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentations 
of the hinge arms into the bottom edges of the hinge slots. The notches in each 
hinge arm must be fully inserted into the bottoms of each slot.
Hinge arm
Hinge arm
Bottom edge of slot
Bottom edge of slot
Indentation
Indentation
3. Open the door fully. If the door will not open fully, the indentations are not 
inserted correctly in the bottom edges of each slot. 
4. Push the hinge locks up against the front frame of the oven cavity into the 
locked position.
Hinge lock
Locked position
Locked position
Unlocked position
Unlocked position
5. Close the oven door.
NX9000T_NX60T8511SS_AA_DG68-01221A-06_EN+MES+CFR.indb 45NX9000T_NX60T8511SS_AA_DG68-01221A-06_EN+MES+CFR.indb 45 2021-03-16 �� 10:18:532021-03-16 �� 10:18:53










