Quick Guide

18 English

Installation instructions

Ground strap

Neutral

terminal

Black

White

Red

Black

White

Red

1. Remove the 3 lower terminal screws

from the terminal block.

2. Insert the 3 terminal screws through

each power cord terminal ring and into

the lower terminals of the terminal

block. Be certain that the center wire

(white/neutral) is connected to the

center lower position of the terminal

block.

3. Tighten screws securely into the

terminal block. DO NOT remove the

ground strap connection.

4. Go to step 6 on page 21 and proceed

with the installation.

Step 4. Installing the power cord

For power cord installations, hook the strain relief over the power cord hole (1⅜")

located below the rear of the drawer body. Insert the power cord through the

strain relief and tighten the device.

Strain relief

Power cord

Conduit connection

plate

• You must install the power cord with a strain relief.

• Attach the strain relief to the 1⅜" opening in conduit connection plate.

Installing a 3-wire power cord

WARNING

The neutral or ground wire of the power cord must be connected to the neutral

terminal located in the center of the terminal block. The power leads must be

connected to the lower left and the lower right terminals of the terminal block.

Install_NY63T8751S_DG68-01304A-00_EN+MES.indb 18 2020-05-08 �� 1:50:24