Quick Guide

English 25
Installation instructions
Checking the ame quality:
All combustion ames need to be visually checked to determine their ame
quality.
2
3
1
1. Soft blue ames—Normal for natural
gas operation.
2. Yellow tips on outer cones—Normal for
LP gas operation.
3. Yellow amesAbnormal for any gas
operation; call for service.
NOTE
If burner ame looks like 3, the range
should not be used until it is serviced. Call
for service. Normal burner ames shall look
like 1 or 2, depending on the gas type you
use.
Step 13. Check the ignition of surface burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
2
1
To turn on a surface burner:
1. Push in and turn the control knob for
that surface burner to the LITE position.
The "clicking" sound indicates the
electronic ignition system is operating
properly. The burner will light in about
4 seconds, after the air has been
purged from the supply line.
2. After the burner lights, turn the control
knob to the desired setting. The
"clicking" sound will stop and the ame
height will change from Max. to Min.
during turning the control knob.
3. Repeat steps 1 and 2 to check the
operation of each surface burner in
succession.
NOTE
Place food in the oven after preheating
if the recipe calls for it. Preheating is
important for good baking results. After
the oven has reached the desired cooking
temperature, it will beep 6 times.
Install_NY63T8751S_DG68-01304A-00_EN+MES.indb 25 2020-05-08 �� 1:50:30