User Manual

52 English
Maintenance
Maintenance
To perform the self-cleaning cycle
Make sure the door lock is released. Remove all racks from the oven cavity.
1. Make sure the oven door is closed completely and unlocked.
2. Tap , and select Cleaning > Self-Clean using the dial knob. Then, select the
cleaning time by turning the dial knob one or more times in accordance with the
table below.
Left turn Default Right turn
2-hour cycle 3-hour cycle 5-hour cycle
3. Tap START. The oven door is locked and the oven begins to heat up.
4. When the self-cleaning cycle is complete, the oven beeps 10 times. The door
will remain locked until the oven temperature falls below 400 °F (200 °C). You
can open the door when it is safe to open.
CAUTION
Do not use the surface burners while the electric oven is performing a self-
cleaning cycle.
WARNING
Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.
NOTE
Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.
To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 on the previous page.
2. Select Set Delay Start.
3. Set the time you want the oven to start self-cleaning using the dial knob.
4. Tap START. The oven will start self-cleaning at your specied time.
To cancel the self-cleaning cycle
You may nd it necessary to stop or interrupt a self-cleaning cycle due to smoke
in the oven. To turn off the self-cleaning cycle, tap OFF. The cycle turns off, but
the door remains locked and the Lock icon blinks until the oven temperature falls
below 400 °F (200 °C).