User Guide
Table Of Contents
- Important safety instructions
- Before you start
- Operations
- Maintenance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Appendix
- Instrucciones de seguridad importantes
- Antes de comenzar
- Funcionamiento
- Encendido del electrodoméstico
- Selección de la zona de cocción y regulación de calor
- Apagado del electrodoméstico
- Uso del bloqueo para niños
- Temporizador
- Control de sincronización
- Activar o desactivar las señales sonoras
- Utilización de los recipientes de cocción correctos
- Selección de los recipientes de cocción correctos
- Protección de la cubierta
- Uso de la función de conexión inteligente
- Uso de la función de control de campana
- Mantenimiento
- Resolución de problemas
- Garantía (EE.UU.)
- Garantía (CANADÁ)
- Apéndice
- Consignes de sécurité importantes
- Avant de commencer
- Opérations
- Mise sous tension de l'appareil
- Sélectionner la zone de cuisson et le réglage de la température
- Mise hors tension de l'appareil
- Utilisation de la fonction sécurité enfants
- Minuterie
- Contrôle synchronisé
- Activation/désactivation du son
- Utilisation des ustensiles de cuisine appropriés
- Choix des ustensiles de cuisine appropriés
- Protection de la table de cuisson
- Utilisation de la fonction connexion intelligente
- Utilisation de la fonction de contrôle de la hotte
- Entretien
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
- Annexe
16 English
Before you start
Before you start
CAUTION
AFTER COOKING
• Do not touch the surface units until they have cooled down.
• The surface may be still be hot and burns may occur if you touch the glass
surface before it has cooled down sufciently.
• Immediately clean spills on the cooking area to prevent a tough cleaning chore
later.
• If cabinet storage is located directly above the cooking surface, make sure
that the items in it are infrequently used and can be safely stored in an area
subjected to heat. Temperatures may be unsafe for items such as volatile
liquids, cleaners, or aerosol sprays.
About the radiant surface elements
The temperature rises gradually and evenly. As the temperature rises, the radiant
element will glow red. To maintain the selected setting, the element will cycle
on and off. The heating element retains enough heat to provide a uniform and
consistent heat during the off cycle. For efcient cooking, turn off the element
several minutes before cooking is complete. This will allow residual heat to
complete the cooking process.
NOTE
Radiant elements have a limiter that allows the element to cycle ON and OFF, even
at the HI setting. This helps to prevent damage to the ceramic cooktop. Cycling at
the HI setting is normal and can occur if the cookware is too small for the radiant
element or if the cookware bottom is not at.
CAUTION
if the cooktop is installed above an oven, do not use the cooktop while the oven’s
Self-cleaning function is on.
Location of the surface elements and controls
Cooking zones
01
02
03
04
05
06
01 Left Rear
(7”, 1500 W)
02 Center
(6”/9”, 3300 W)
03 Right Rear
(6”, 1200 W)
04 Left Front
(7”, 1500 W)
05 Right Front
(5”/8”, 2000 W)
06 Control Panel
NZ30K7570R_DG68-00821B-04_EN+MES+CFR.indb 16 2018-03-09 12:04:15