User Manual
Table Of Contents
- Important safety instructions
- Before you start
- Operation
- Switching the appliance on
- Selecting a cooking zone and power setting
- Switching the appliance off
- Using the child lock
- Timer
- Power boost control
- Power management
- Pause
- Flex zone
- Sound on/off
- Virtual flame on/off
- Before using the cooktop
- Cookware for induction cooking zones
- Using the correct size cookware
- Pot and pan sizes
- Operating noises
- Using suitable induction cookware
- Temperature detection
- Protecting the cooktop surface
- Using the smart connect feature
- Using the hood control feature
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Appendix
- Instrucciones de seguridad importantes
- Antes de comenzar
- Operación
- Encendido del electrodoméstico
- Selección de una zona de cocción y un ajuste de potencia
- Apagado del electrodoméstico
- Uso del bloqueo para niños
- Temporizador
- Control de más potencia
- Gestión de potencia
- Pausa
- Zona Flex
- Activar o desactivar las señales sonoras
- Encendido/apagado de la llama virtual
- Antes de usar la cubierta
- Utensilio de cocina para zonas de cocción por inducción
- Uso del tamaño de utensilio de cocina correcto
- Tamaño de ollas y sartenes
- Ruidos de funcionamiento
- Usar utensilios de cocina adecuados para inducción
- Detección de temperatura
- Protección de la superficie de cocción
- Uso de la función de conexión inteligente
- Uso de la función de control de campana
- Mantenimiento de su electrodoméstico
- Resolución de problemas
- Garantía limitada (Estados Unidos)
- Garantía (CANADÁ)
- Apéndice
- Consignes de sécurité importantes
- Avant de commencer
- Fonctionnement
- Mise sous tension de l'appareil
- Sélectionner une zone de cuisson et un réglage de puissance
- Mise hors tension de l'appareil
- Utilisation de la fonction sécurité enfants
- Minuterie
- Commande pleine puissance
- Gestion de la puissance
- Pause
- Zone flex zone
- Activation/désactivation du son
- Activation/désactivation de la flamme virtuelle
- Avant d'utiliser la table de cuisson
- Récipients pour les zones de cuisson à induction
- Utiliser des récipients de taille adaptée
- Tailles de récipients et de casseroles
- Bruits de fonctionnement
- Utilisation des récipients adaptés à la cuisson à induction
- Détection de la température
- Protection de la surface lisse
- Utilisation de la fonction connexion intelligente
- Utilisation de la fonction de contrôle de la hotte
- Entretien de votre appareil
- Dépannage
- Garantie (États-Unis)
- Garantie (CANADA)
- Annexe
English 33
Troubleshooting
Problem Possible cause Solution
The surface unit
frequently cycles
on and off.
The element will cycle on
and off to maintain the
power setting.
This is normal operation, and
not a system failure. Cycling
at the high power setting is
normal and can occur if the
cookware is too small for the
cooktop element or if the
cookware bottom is not at.
Use the cooktop as usual.
Scratches or
abrasions on the
cooktop surface.
The cooktop is being cleaned
improperly.
Scratches are not removable.
Tiny scratches will become
less visible in time as a result
of cleaning. Use ceramic glass
top cleaning cream. Do not
use chemical or corrosive
agents. These agents may
damage the surface of the
product.
Cookware with rough
bottoms was used on the
cooktop or there were
coarse particles (eg. salt or
sand) present between the
cookware and the surface of
the cooktop.
To avoid scratches, follow
the recommended cleaning
procedures. Make sure
cookware bottoms are clean
before use, and use cookware
with smooth bottoms.
Cookware has been slid
across the cooktop surface.
Problem Possible cause Solution
Brown streaks or
specks.
Boilovers have been cooked
onto the surface.
• Wait until the surface
cools down. Then, use a
single-edge razor-blade
scraper at approximately
a 45° angle against the
glass surface to remove
the soil.
• See the section on the
care and cleaning of the
glass cooktop on page 30.
Areas of
discoloration
with metallic
sheen.
Mineral deposits from water
and food have been left on
the surface of the cooktop.
• Remove using a ceramic-
glass cooktop cleaning
cream.
• Use cookware with clean,
dry bottoms. Clean the
cooktop with a ceramic
cleaning agent regularly
every week.
"Cracking" or
"popping" sound.
This is the sound of the
metal heating and cooling
during cooking.
This is normal operation and
not a system failure. Use the
cooktop as usual.
NZ30K7880U_DG68-00823A-07_EN+MES+CFR.indb 33NZ30K7880U_DG68-00823A-07_EN+MES+CFR.indb 33 2022-11-23 오후 1:46:402022-11-23 오후 1:46:40