Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-72 © SAMSUNG Electronics Co., Ltd.
300 Customer On/Off per Station
Allows the following features to be enabled on a per-station basis.
No Option Default Description
00 ACCESS DIAL ON Determines whether a user can select a trunk or trunk
group by dialling its directory number(DN). This selection
should be turned to off when using LCR.
01 MICROPHONE ON Allows all 12 and 24 button phones to be used in the
speakerphone mode.
02 OFF-HOOK RING ON Will allow a short burst of ring tone to indicate another call.
03 SMDR PRINT ON When the station is set for no Trunk Line calls to and from
this station, the station will not print on SMDR.
This includes transferred calls or calls picked up from
hold or park.
04 TGR ADV.TONE ON When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
05 VMAA FORWARD ON This feature selects whether Trunk Line calls can be
forwarded to voice mail. When ON, Permits forward to
voice mail. When OFF, No forward to voice mail.
07 NGT PASSCODE ON When ON, the steps verifying the RING PLAN passcode
will be added in Ring Plan change.
08 INTRCOM SMDR OFF When the station is set to OFF, the station will not print
intercom calls on SMDR.
09 FWD DLY USE OFF When the station is set to ON, if the station has no
answer forward number without no answer forward set
then a call both ringing original extension and no answer
forward number when a incoming call is directed to the
station and the station does not answer until no answer
forward time.
11 FORWARD OVRD OFF When the station is set to ON, if the station call to
forwarded station, the call will not forward.
12 RECL TO OPER OFF When the station is set to ON, if the station transfer a call
and the destination doesn’t answer, the call will be recall
to operator instead of the station.
13 SLT PWR DISC OFF When the normal phone is set to ON, if the station
receives real disconnect signal instead of busy tone or
error tone. In case of VMAA ports or DATA RING ports
are not reference this option, this type SLI ports are
always receives real disconnect signal.