Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-94 © SAMSUNG Electronics Co., Ltd.
315 Customer Set Relocation
Customer Set Relocation allows System Administration level or Technician level
access to relocate or exchange similar stations in the system without wiring changes
(see Allow Table bellow). This program is a one for one exchange with like stations.
e.g., Single line to single line, 6 button phone to 6 button phone, etc.
All individual station assignments such as trunk ring, station group, station COS,
station speed dial, button appearances, etc. will follow the Customer Set Relocation
program. 12 button phones and 24 button phones can be exchanged. 48 button
modules and 64 button modules can also be exchanged. Single line stations numbers
can be exchanged. If incompatible set types are selected the system will provide an
ERROR : NO MATCH message. If 48 or 64 button module units are to be exchanged
the Master assignment must be removed prior to using Customer Set relocation.
If the 48 or 64 button module Master station is not removed the error code ERROR :
NOT ALONE will appear on the LCD display. A station must be in the idle state(on
hook) to perform Customer Set Relocation. If a wired location has a station port
connected but no telephone instrument the Customer Set Relocation program will
allow set relocation as long as the station types are similar.
12 button and 24 button assignments should be taken in consideration when
relocating these types of sets due to the button configurations of the instruments.
If a 12 button set and a 24 button set are exchanged using the Customer Set
Relocation program the first twelve buttons on the 24 button set will have the button
programming of the 12 button set. The 12 button set will then have the programming
of the first twelve buttons of the 24 button set. In other words, when exchanging 12
and 24 button set only the first twelve buttons will swapped.
Customer access to this feature is default OFF in MMC 802.