Installation guide

CHAPTER 1

Before Programming

In this chapter, the things to know before you start MMC programming, and the

phone buttons and cautions will be discussed.

1 Introduction to Programming

The MMC program means the changes on the data that is used for the system

operation program. There are 3 levels of MMC programming, such as technician,

operator, and station levels. According to the programming level, the station can

program or cannot program the data change. The technician level programming and

the operator level programming require a passcode for each level while the station

level programming does not require a passcode.

1.1 Technician

Level Program

This level is allowed to program every level of program.

This level of programming can be done on every phone within the system, but it can

be done for only one phone at a time.

1.2 Operator

Level Program

An technician can do programming within the range set by the MMC 802-Operator

Program Range Setting.

Programming is allowed for any phone within the tenant group, but it can be done for

only one phone at a time.

1.3 Station

Level Program

Programming can be done for only station level programs.