Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-140 © SAMSUNG Electronics Co., Ltd.
425 Assign Caller ID Trunks
Allows the system administrator or technician to activate analog loop trunk Caller ID
on a per-trunk basis. Activating Caller ID will delay the incoming ring indication at
the operator by two ring cycles to allow for the collection of the calling party data.
Each trunk has the following options :
No Option Description
0 NORMAL This is not a Caller ID trunk.
1 CID TRUNK This is a Caller ID trunk.
Supports Bellcore type data only for Caller ID, others type will not supports. Available
in Australia, Israel and Italy only.
PROGRAM BUTTONS
!
VOLUME Used to scroll through options
!
KEYPAD Used to enter selections
!
SOFT Move cursor left and right
!
SPEAKER Used to advance next MMC
!
ANS/RLS Used to select ALL
ACTION
PROCEDURE DISPLAY
1. Press Transfer button and enter 425
Display shows
[701] CID TRUNK
NORMAL
2. Dial trunk number(e.g., 702)
OR
[702] CID TRUNK
NORMAL
Press Volume button to select trunk and press
Right Soft button to move cursor
OR
Press ANS/RLS button to select ALL
[ALL] CID TRUNK
?
3. Dial 0, 1 or 2 to change options
OR
[702] CID TRUNK
CID TRUNK