Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-150 © SAMSUNG Electronics Co., Ltd.
500 System-Wide Counters
Used to set the values of the system counters. The counters are listed below with a
brief description of each.
No Counter Default Description
0 ALARM REM. CNTER 5 The number of times that an alarm reminder will ring a
station before cancelling. RANGE=1-99.
1 AUTO RDL COUNTER 3 The number of times the system will redial an outside
number after the auto redial feature has been
activated. RANGE=1-99.
2 DISA CALL CNTER 99 Sets the maximum number of intercom calls that can
be made after accessing a DISA line. RANGE=1-99.
3 DISA LOCK CNTER 3 Number of attempts the system will allow to
incorrectly access a DISA line before locking out the
DISA line. RANGE=-99
4 NEW CALL COUNTER 99 Number of times the system will allow a user to signal
New Call on a Trunk line during one call. RANGE=1-
99.
PROGRAM BUTTONS
!
VOLUME Used to scroll through options
!
KEYPAD Used to enter selections
!
SOFT Move cursor left and right
!
SPEAKER Used to advance next MMC
ACTION
PROCEDURE DISPLAY
1. Press Transfer button and enter 500
Display shows
ALARM REM.CNTER
05
"
2. Enter number from above list(e.g., 6)
OR
UCDS AUDIO ALARM
00
"
Press Volume button to make selection and
press Right Soft button to move cursor
3. Enter in new value via dial keypad
If entry is valid, system will return to step 2
UCDS AUDIO ALARM
00
"
02
4. Press Transfer button and enter to exit
OR
Press Speaker button to advance next MMC