Installation guide

CHAPTER 1. Before Programming OfficeServ 12 Programming Guide/Ed.00
Page 1-6 © SAMSUNG Electronics Co., Ltd.
3 Cautions in Programming
!
Programming can be done while the handset is placed on the phone at a idle
state.
!
Programming can be done on any phone.
!
Programming can be done only on the phone, not on normal phone.
!
If the phone does not have the LCD display, press the numbers using the dial
buttons as instructed by the programming guide, without using the volume
buttons. However, if the phone does not have Soft buttons, certain programming
cannot be done. Therefore, only the station level programming is allowed on the
phone that does not have the LCD display.
!
If the LCD displays an ‘INVALID DATA’ message while programming, this
means that the entered data is invalid. Enter the correct data again.
!
The content of the displayed message for each step shows the status after each
step is executed.
!
If no key is pressed for a certain period of time during programming (Key
program end time, default is 60 seconds), it becomes a idle state from
programming mode.
!
If the phone is off hook while programming, it becomes a dial state from
programming mode.
!
Before the modified data is confirmed by pressing Left Soft button or Right Soft
button, the Speaker or Transfer button is pressed to make it at a idle state or the
phone is unplugged. In this case, the data entered up to that time will be
automatically saved as the data displayed on the LCD.