Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-180 © SAMSUNG Electronics Co., Ltd.
601 Assign Station Group
This MMC is used to build all station groups. There are 10 programmable groups
available in a OfficeServ 12 system.
The options for setting up these groups are as follows :
No Option / Description
0 TYPE : This is the type of group you are creating and can be one of the following :
0 NORMAL : Used to assign stations in a ring group. The members can be stations,
common bell contacts.
1 VMAA GROUP: Used to group a number of voice mail port extensions. These must have
been defined in MMC 207 as VMAA ports or they cannot be entered here. Check all
programming in MMC 726 to ensure that the In band DTMF codes are properly set.
2 SVM GROUP : Voice mail group for the SVM-400. Can only have distribute or sequential
ringing.
1 RING MODE : Each group can have one of the following ring modes. This will decide how
calls are placed to the group.
0 SEQUENTIAL : The stations listed as 'members'(see below) will be called on a first
available basis. Calls will first go to the first member, if the first member is busy, calls will
go to the second member, if the second member is busy, calls will go to the third member
etc. This type of group is useful for placing the bulk of the incoming calls to a selected
individual, with other members only getting the calls when the first member is busy.
The number of members allowed for a sequential group is 20.
1 DISTRIBUTED : The first call will go to the first member, the second call will go to the
second member, the third call will go to the third member. This type of group is useful for
evenly distributing the call among all group members. The number of members allowed
for a distributed group is 20.
2 UNCONDITIONAL : Calls are placed to all group members simultaneously. This reduces
the number of members of the groups to 8. If a group member is busy, they can receive
off hook ring if defined in MMC 300. This ring mode option is not available for VMAA
group. The SGR INC BUSY option is not available for unconditional ring mode.
2 OVERFLOW : This is the timer value that will cause unanswered calls to a group to begin
also ringing the NEXT PORT(see below) after this timer has elapsed. If set to 000, no
overflow will take place.
3 GROUP TRANSFER : This is a timer that will determine how long Trunk Line calls transferred
to the group will ring at the group before recalling. If set to 000, no recall will take place.