Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming

602 Station Group Name

Allows the system administrator or technician to enter an 11-character name to

identify an individual station group.

Names are written using the keypad. Each press of a key selects a character. Pressing

the next key moves the cursor to the next position. For example, if the directory name

is ‘SAMSUNG,’ press the number ‘7’ four times to get the letter ‘S’. Now press the

number ‘2’ once to get the letter ‘A’. Continue selecting characters from the table

below to complete your message. Pressing ‘A button’ changes the letter from upper

case to lower case.

When the character that you want appears on the same dial keypad key as the

previous character, press the Volume Up button to move the cursor to the right or the

Volume Down button to move cursor left. A space can be entered by using these

keys.

When the character you want appears on the same dial keypad key as the previous

character, press the Volume Up button to move the cursor to the right.

Count 1 2 3 4 5

DIAL 0 < > . ) 0

DIAL 1 Space ? , ! 1

DIAL 2 A B C @ 2

DIAL 3 D E F # 3

DIAL 4 G H I $ 4

DIAL 5 J K L % 5

DIAL 6 M N O ^ 6

DIAL 7 P Q R S 7

DIAL 8 T U V * 8

DIAL 9 W X Y Z 9

DIAL * : = [ ] *

The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,, %,

$, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,",

,` , and \.