Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming
© SAMSUNG Electronics Co., Ltd. Page 2-185
603 Assign Trunk Group
Allows the assignment of trunks to a specific trunk group or to several trunk groups.
This is very useful in the programming of LCR when more than one trunk is to be in
several dialling plans. There are two different modes of operation : (1) sequential and
(2) distribute. There are 10 programmable trunk groups with up to 30 members per
group.
One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
PROGRAM BUTTONS
!
VOLUME Used to scroll through options
!
KEYPAD Used to enter selections
!
SOFT Move cursor left and right
!
SPEAKER Used to advance next MMC
!
HOLD Used to clear previous entry
ACTION
PROCEDURE DISPLAY
1. Press Transfer button and enter 603
Display shows
[9] TRK GROUP
MODE:SEQUENTIAL
2. Enter in valid trunk group(e.g., 9)
OR
[9] TRK GROUP
MODE:SEQUENTIAL
Press Volume button to make selection and press
Right Soft button to advance cursor
3. Press Right Soft button to change mode
OR
[9] TRK GROUP
MEMBER 01:NONE
Press Volume button to change mode to member
4. Press Right Soft button to move cursor to
number of member and enter valid member
[9] TRK GROUP
MEMBER 05:NONE
number (e.g., 05) via dial keypad
OR
Press Volume button to make selection and press
Right Soft button to move cursor