Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-212 © SAMSUNG Electronics Co., Ltd.
705 Assign System Speed Dial
Enables the assignment of system speed dialling numbers. There are up to 500 entries
available for programming(see MMC 606). Each speed dial number consists of a
trunk or trunk group access code followed by a separator and up to 24 digits to be
dialled. These dialled digits may consist of 0-9, and #. If the system recognises a
valid trunk or trunk group access number, it will automatically insert the separator.
PROGRAM BUTTONS
!
VOLUME Used to scroll through options
!
KEYPAD Used to enter selections
!
SOFT Move cursor left and right
!
SPEAKER Used to advance next MMC
!
HOLD Used to clear previous entry
!
B Used to insert a flash code ‘F’
!
C Used to insert a pause code ‘P’
!
D Used to insert a pulse/tone conversion code ‘C’
!
E Used to mask/unmask following digits-shows as ‘ [’ or ‘]’
!
F Used to enter name for speed dial bin(see MMC 706)
!
ANS/RLS Used to save the speed dial number and name to the MMC 728
CID translation table.
ACTION
PROCEDURE DISPLAY
1. Press Transfer button and enter 705
Display shows
SYS SPEED DIAL
500:
2. Dial speed index desired(e.g., 505)
OR
SYS SPEED DIAL
505:
Press Volume button to make selection and
press Right Soft button to move cursor
3. Enter access code(e.g., 9/701) plus the phone
number up to 24 digits(digits will scroll under)
SYS SPEED DIAL
505:9–121223456789
and press Right Soft button to return to step 2
4. Press F key to toggle to MMC 706 step 3 to
enter name
SYS SPEED NAME
505: