Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-218 © SAMSUNG Electronics Co., Ltd.
709 Toll Pass Code/Special Code Table
This MMC provides a means to program three trunk code tables as described below :
Code Type Description
PBX CODE This table contains up to five entries and is used to identify the trunk
access codes needed for toll restriction to be properly applied when the
system is used either behind a PBX or with CENTREX-supplied dial tone.
Toll restriction will only be applied on trunks flagged as PBX in MMC 401 if
a trunk access code entered in this table is dialled. Toll restriction will be
applied to the digits following the trunk access code.
SPECIAL CODE This table identifies to the system dialling rules the special feature codes
used to activate central office custom calling features such as CID Block
and call waiting disable. The special feature codes can be used on a per
call basis without affecting LCR or toll restriction programming. There is a
maximum of ten(10) entries available each of which may be up to four
digits long.
TOLL OVERRIDE This table of eight entries is used to identify to the system numbers that will
bypass all dialling restrictions. This bypass includes Toll restriction, Trunk
access and forced authorization or account codes. Each entry in the table
can be up to 14 digits long.
OVRD USE TRK GRP This entry designates the trunk group that toll override calls will access.
PROGRAM BUTTONS
!
VOLUME Used to scroll through options
!
KEYPAD Used to enter selections
!
SOFT Move cursor left and right
!
SPEAKER Used to advance next MMC
!
HOLD Used to clear previous entry
ACTION
PROCEDURE DISPLAY
1. Press Transfer button and enter 709
Display shows
PBX ACCESS CODE
1:
2. Select PBX , SPECIAL CODE, TOLL
OVERRIDE or OVRD USE TRK GRP
TOLL OVERRIDE
1:
OR
Press Volume button to make selection and
press Right Soft button to move cursor