Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00

Page 2-228 © SAMSUNG Electronics Co., Ltd.

714 DID Number And Name Translation

Assigns an incoming DID call to a specific ring plan destination. It also provides a

call waiting option, if needed, so that a second incoming DID call can be received.

The table is also used to define which MOH source a caller to that DID number will

hear when placed on hold. An 11 character name can be added to the number.

There are a maximum of 999 entries. If there is no matching number on DID service

the call is routed to the operator group.

Definitions of option are as follows :

DGT

Digits to be received from Trunk line Up to 16 digits may be entered.

MOH SOURCE

: Allows the technician to select what the calling party will

hear in regards to that DID/DNIS number if the call is placed on hold.

1 : XXX, 2 : XXX, 3 : XXX, 4 : XXX, 5 : XXX, 6 : XXX

=ring plan and

destination during each ring plan. The destination can be a station, station

group, trunk or trunk group. If trunk or trunk group is selected the trunks must

be programmed as E&M trunks to allow the received digits to be re-sent on the

facility(s). This is referred to as DID Repeat digits over tie line.

An entry of the character ‘B’ means to repeat the received digits.

: Call waiting Yes/No . Allow a second DID call to be received

: The number of maximum call count. When this sets 99, this feature will

not works. When this sets 0, if a call comes that matched DID digits and DGT

field then the system will be reject call. When this sets between 1 to 98, if a call

comes that matched DID digits and DGT field then the system counts same DID

digits call, and in case of the count is same or higher than this value, the system

sends busy signal to caller.

: The number of digits to delete. This is useful with Tandem switching,

mixed numbering plans and DID Repeat digits over tie line. Maximum number

of digits that can be deleted is 16.

NAME

: Input up to 11 characters to identify call.

Names are written using the keypad. Each press of a key selects a character. Pressing

the dial keypad key moves the cursor to the next position. For example, if the directory

name is ‘SAM SMITH,’ press ‘7’ four times to get the letter ‘S’. Press ‘2’ once to get