Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-232 © SAMSUNG Electronics Co., Ltd.
715 Programmed Station Message
Allows custom messages to be programmed or default messages to be changed.
Messages are written via the keypad. Each press of a key will select a character.
Pressing a different key will move the cursor to the next position. For example, if the
message is ‘Sunbathing,’ press the number ‘7’ four times to get the letter ‘S’.
Now press the number ‘8’ twice to get the letter ‘U’. Continue selecting characters
from the table below to complete your message. Pressing the A button will change
the letter from upper case to lower case.
When the character you want appears on the same dial keypad key as the previous
character, press the Volume Up button to move the cursor to the right or the Volume
Down button to move the cursor to the left. A space can be entered by using these
keys.
Count 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V * 8
DIAL 9 W X Y Z 9
DIAL * : = [ ] *
The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,,
%, $, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,",
"
,` , and \.
There are 15 messages in the system.
MESSAGES 01-10 are 16 character pre-programmed default messages. Any of them
can be changed.
MESSAGES 11-15 are 16 character blank messages that can be created.