Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming
© SAMSUNG Electronics Co., Ltd. Page 2-251
No Option Default Description
15 INCOMING
ANSWER
NO If this option is set to YES, the duration of calls ringing
before answered will print on SMDR.
16 INTERCOM CALL NO This option determines whether intercom calls will print
on SMDR.
17 KEY MMC IN/OUT NO If set to YES then the SMDR record will show programming
being opened and closed in MMC 200 and MMC 800.
23 DID NUM/NAME YES If this option is set to YES, received DID information will
print on SMDR.
24 ITP
REGISTRATION
NO If set to YES then the SMDR record will show IP-based
station to system connect and disconnect.
25 SET RELOCATION NO If set to YES then the SMDR record will show set
relocated information.
Names are written using the keypad. Each press of a key selects a character. Pressing the next
key moves the cursor to the next position. For example, if the directory name is SAM
SMITH, press the number 7 four times to get the letter S. Now press the number 2 once to get
the letter A. Continue selecting characters from the table below to complete your message.
Pressing A button changes the letter from upper case to lower case.
When the character you want appears on the same dial keypad key as the previous
character, press the Right Soft button to move the cursor to the right.
Count 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V * 8
DIAL 9 W X Y Z 9
DIAL * : = [ ] *
The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,,
%, $, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,",
"
,` , and \.