Installation guide

CHAPTER 1. Before Programming OfficeServ 12 Programming Guide/Ed.00
Page 1-14 © SAMSUNG Electronics Co., Ltd.
5Overview of Programming Procedure
Here, the order of programming will be discussed before explaining programming
method of each list. Please read the description carefully before programming.
The programming order is as follows :
1) Make the programmable state.
!
Press the Transfer button at pause.
!
Enter the program number, either 200 or 800.
!
Enter either the operator passcode or the technician passcode.
!
Press 1 dial button to ‘enable’ the programming mode.
!
In case of Program 800 Technician Program Mode Setting, enter the tenant
number to be programmed.
2) Make the program number selectable state.
If the Speaker button is pressed, the program selection mode appears.
Or, if the Transfer button is pressed, the programming state ends and the pause
state begin.
3) Select a program.
Enter the program number.
Or, select the program number with the Volume button and press the Speaker
button.
Or, Press Transfer button in a pause state and enter the program number.
4) Start programming the corresponding program.