Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-256 © SAMSUNG Electronics Co., Ltd.
EXAMPLES OF VM/AA OPERATION(IN BAND DTMF DIGIT STRING)
In the following example, all call and type data is turned on unless otherwise stated.
X is the separator digit, all-default values are used in these examples and [ ] is not
used.
A DIL 701 calls a VM/AA port or group :
[ * ]+[701]+[ ]+[ ]
In the above example, if Trunk Line information is not used :
[ ]+[ ]+[ ]+[ ] (Nothing is used)
DIL 701 calls a call-forwarded station(205) :
[ # ]+[205]+[ X ]+[701]
In the above example, if forward information is not used :
[ ]+[205] +[ X ]+[701]
In the above example, if forward and DN2/Trunk Line information is not used :
[ ]+[205]+[ ]+[ ]
DIL 701 calls group 501 that overflows to VM/AA :
[ # ]+[501]+[x]+[701]
In the above example, if overflow information is turned off :
[ ]+[ ]+[ ]+[ ] (Nothing is sent)
A DID call rings the VM/AA directly :
[ B ]+[9999]+[ ]+[ ]
9999 are the DID digits from Trunk Line
In the above example, if did information is turned off :
[ ]+[9999]+[ ]+[ ]
A station transfers(blind or screened) a call(Trunk Line, DID or intercom) to VM/AA
group or port. When the transferring station hangs up(blind transfer) :
[ ]+[ ]+[ ]+[ ] (Nothing is sent)
A station(202) transfers a Trunk Line call(702) to a station(225) that is Call Forward
All to a VM/AA group or port. When the transferring station hangs up(blind transfer)
and the VM/AA group or port answers :
[ # ]+[225]+[x]+[702]