Installation guide

CHAPTER 2. MMC Programming OfficeServ 12 Programming Guide/Ed.00
Page 2-260 © SAMSUNG Electronics Co., Ltd.
728 CID Translation Table
Allows the system administrator or technician to associate a CID number received
from the central office with a name programmed in this translation table. If there is
no match between a received number and a name in this table, ‘no CID name’ will be
displayed.
The translation table consists of 1000 entries for a OfficeServ 12 system . Each entry
is comprised of a ten-digit(14 digits allowed) telephone number and a 16-digit name.
Names are written using the keypad. Each press of a key will select a character.
Pressing the next key will move the cursor to the next position. For example, if the
directory name is ‘SAM SMITH, ’ press the number ‘7’ four times to get the letter
‘S’. Now press the number ‘2’ once to get the letter ‘A’. Continue selecting characters
from the table below to complete your message.
When the character you want appears on the same dial keypad key as the previous
character, press the VOL Volume Up button to move the cursor to the right.
Count 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V * 8
DIAL 9 W X Y Z 9
DIAL * : = [ ] *
The # button can be used for the following special characters: #, space, &, !, :, ?, ., ,,
%, $, -, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,",
"
,` , and \.