Installation guide

OfficeServ 12 Programming Guide/Ed.00 CHAPTER 2. MMC Programming

832 VOIP Access Code

Provides a means to apply the Internet Protocol(IP) address to the VoIP gateway.

This MMC also assigns the number of channels that can be used for IP faxes.

No Parameter Description

O/I TABLE(00-62) Outbound or Inbound table use for specific access codes. Usually when the

system is used as a VoIP gateway the Outbound table is used.

The Inbound table is used to determine the number of digits to receive

before processing the call. Each table has 63 entries(00-62).

0 ACCESS DGT This is the access code that is used once the VoIP gateway is accessed; this

directs a call based on the routing tables used. An access code table then

references an access code and correlates an IP address to the access code

for routing. A maximum of 8 digits are available.

1 DGT LENGTH This field requests the number of digits that are expected to be received to

make up the whole access code.

2 DEL.LENGTH This is the number of digits to delete after receiving the access code. If no

digits are deleted the access code will be sent as part of the call to the

destination to continue routing at the far end destination.

3 INSERT DGT This is the digit(s) to insert for routing at the destination. This can be used

when different numbering plans exist or if a dial 9 access is needed to be

inserted in the dialled digits.

4 IP TABLE 1 This is the first table referenced for routing the access code to an IP

address. The system has 64 IP tables(00-63) with 16 entries(00-15) in each

table. See MMC 833.

5 IP START This entry indicates where in a table to start looking for an IP code to

associate with the access code. This can be used to manage where to start

looking for an IP address in high traffic VoIP gateway applications.

Example) If IP address routing to the desired destination is known to be in

the last 7 entries of a table the IP START location would be 8. IP address

searching would start at entry 8.

6 GK USE This parameter determines whether a H.323 Gatekeeper will be utilized to

establish this connection.

PROGRAM BUTTONS

VOLUME Used to scroll through options

KEYPAD Used to enter selections

SOFT Move cursor left and right

SPEAKER Used to advance next MMC